VILLBAU Enigma II Installation Manual download pdf

VBIP Install Manual

V1.00

Page 1/4

www.villbau.com

1. Overview

The VBIP Module can be used to connect any control panel, with telephone communicator, supporting Contact ID

format, to the local network (LAN) or internet (WAN), and report the control panel events to the monitoring station via

the IP network.

2. Installation

The installation of the VBIP Module requires basic

knowledge of the Ethernet network and the IP

protocols. If you do not familiar with these topics,

please, consult with an IT professional, or system

administrator before attempting the installation.

The VBIP Module should be installed next to the control

panel. Power can be supplied to the module from the

AUX power terminals of the control panel. The module

telco interface can be connected directly to the

TIP/RING terminals of the control panel telephone

communicator. For the connection to the ethernet

network there is an RJ45 modular jack on the module.

Use a Cat 5, or better, UTP patch cable for the

connection to the router.

The installation process

Before installation, the VBIP Module has to be properly

programmed. (see. Section 3. Programming).

• Choose a proper position for the module in the box

of the control panel. If connecting directly to the

TIP/RING terminals, take care for arranging the

cables to avoid mechanical stress to the module

• Connect the power cable (2.54mm pitch connector)

to the AUX power terminals of the control panel and

check for correct polarity. Then the power cable can

be plugged on to the module. A few seconds after

powering up the module will start and the Status

LEDs will blink.

More Info: 4.1 Status LED display

• Connect the UTP cable to the module jack – then

the VBIP Module will try to connect to the network

according to its settings. The network status can be

followed on the LEDs

More Info: 4.2 Network LED display

If programmed properly, the module is now ready for

operation and it sends its reset and test message to the

monitoring station.

3. Programming

The parameters of the VBIP Module have to be

programmed properly for problem free operation. For

the programming, the EniTerm software can be used

with the VBIP USB programming adapter. The EniTerm

software can be downloaded from www.villbau.com

free.

ATTENTION!!! During programming the module is

powered from the PC USB port (5 VDC).

NEVER CONNECT THE USB PROGRAMMING

ADAPTER AND THE POWER CONNECTOR AT THE

SAME TIME! DOING THAT CAN CAUSE SERIOUS

DAMAGE TO THE MODULE AND/OR TO THE PC.

1 2 3 4

VBIP Install Manual 1

Summary of Contents

Page 1 - VBIP Install Manual

VBIP Install Manual V1.00 Page 1/4 www.villbau.com 1. Overview The VBIP Module can be used to connect any control panel, with telephone com

Page 2

VBIP Install Manual V1.00 Page 2/4 www.villbau.com The following sections detail the network and telephone communication parameters of the module. 3.

Page 3

VBIP Install Manual V1.00 Page 3/4 www.villbau.com Telnet Server The VBIP Module has a built-in Telnet server, which can be used for remote a

Page 4

VBIP Install Manual V1.00 Page 4/4 www.villbau.com PGM Options In case the I/Os are programmed as outputs, their output functions can be p

VILLBAU Enigma II Installation Manual

Browse online or download Installation Manual for Receiver VILLBAU Enigma II. VILLBAU Enigma II Installation manual User Manual

Summary of Contents

More documents for Receiver VILLBAU Enigma II

Comments to this Manuals